Govoni Handling System - Deutsch
Govoni Handling System - English
Govoni Handling System - Italiano
Products
Website
Chip shredders
Usually the shredders are installed above the centrifuge in de-oiling systems in order to reduce the dimensions of the swarf.
The shredders consist of a loading hopper, a crushing unit and a discharge unit and are equipped with a motor, electrical panel and control PLC in order to be able to visualize the functioning and efficiency by means of safety devices.
The crushing unit consists of two shafts acting respectively on the circular blades and counter-blades equipped with hooks. The swarf which falls into the hopper is captured by the hooks and then led to the cross of the blades and counter-blades where they are cut and shredded and then fall due to gravity into the drop chute below.
The shredding occurs at low rotation speeds, allowing high performance with minimum power consumption and reduced wearing of the blades.
In case of accidental entry of pieces too hard for crushing, the working overload activates automatic reversal of the rotor and if the system is unable to eliminate them after a few attempts, it stops to allow its manual removal.

Advantages:

  • long lasting blades very resistant to wear and tear
  • ease of replacement of components
  • high crushing power with little energy consumption
  • low noise level
SHREDDER SERIES 'TR-A':
Double shaft shredder suitable for shredding medium, long, flowing metallic chips in a continuous loop and with reduced flow rates depending on the model. The chips cross the crushing unit consisting of rotating blades and counter blades made of deep hardened steel which are adjustable and easily replaceable. The series includes various models with capacities ranging from 30 to 400 kg/h depending on the material to be treated and the morphology of chips.
SHREDDER SERIES 'TR-B':
Double shaft shredder suitable for crushing long and strong bundled chips in a continuous loop, even with significant flow rates and materials difficult to manage. The material placed in the hopper is conveyed to the crushing unit consisting of resistant rotating blades and counter-blades made of deep hardened steel which are adjustable and easily replaceable. The high grinding capacity allows for the reduction of the material into small fragments which are then discharged to the outside.
The series includes several models with a capacity that can vary from 150 to 1500 kg/h depending on the material to be treated and of the morphology of the chips.

SERIES 'TR-A'

MODELS/FLOW RATE kg/h

Material

TR-A 300

TR-A 400

Steel

30 - 150

150 - 400

Aluminium

20 - 50

50 - 150

Brass

30 - 100

100 - 250

These data may vary depending on the morphology of the chips and the specific weight of the material.

SERIES 'TR-B'

MODELS/FLOW RATE kg/h

Material

TR-BM 500

TR-BM 600

Steel

400 - 1000

1000 - 1500

Aluminium

150 - 400

400 - 600

Brass

250 - 700

700 - 1100

These data may vary depending on the morphology of the chips and the specific weight of the material.


INFORMATION REQUEST
2020 Govoni Handling Systems S.r.l. - Registered office: Via Bologna 21, 44042 Cento (FE)
Share Capital: 97,500.00 fully paid up - VAT code: 01298160381 - Company Register of FE and Tax Code: 01298160381